ULTIMATE series TA2 is a HiFi extremely well-sounding amplifier for car use. We did not compromize in any section of the construction when we designed the electronic circuits. The TA2 is using the very best components in all sections of the amplifier, from the input circuitry, through the whole amplifier to the final output stage. Two pieces of CV4010 pentodes is used in the signal path. These tubes are made by VALVE Electronics in England during 1982 - 1984. The Valve Electronics company produced best sounding tubes in the tube industry before they closed. The tubes are spare parts for military equipment so they fulfil military specifications. We use silver wire Capacitors in signal path and power supply for a focused sound image. Special designed DLS Audio capacitors in key points and WIMA polypropylene capacitors. Four pieces of 4700 uF on each channel for a deep and wide sound stage. Dual mono power system design plus separate power supply for tube and pre-amp stage for clear sound reproduction.

Warm / Cool tube illumination display

RMS Output power in 4 ohm : 2 x 100 watt
RMS Output power in 2 ohm : 2 x 200 Watt

20 Hz - 20 kHz ,
< 0,1% distortion. Mode : AB
Number of channels : 2
Frequency response : 10 Hz - 50 kHz
THD at 1 W : < 0,04%
S / N ratio, A-weighted : > 102 dB
Damping factor : > 240
Input impedance : > 10 kohm
Input sensitivity, variable : 0,5 - 7 V
Filter, highpass, variable : 20 - 200 Hz, 12 dB slope
Double DC-inputs : Yes, one for each channel
Max cable size DC input : 16 mm2 (AWG5)
Max cable size speaker output : 16 mm2 (AWG5)
Current draw, idle : 1,5 A
Current draw, maximum : 40 A
Dimensions W x D x H : 410 x 240 x 73 mm
(16,15 x 9,45 x 2,87 inch)
Weight : 6,2 kg ( 13,67 lb)