| Classic series CA30 The
Classic CA 30 is a three channel amplifier with a nominal output
of 2 x 50 Watts + 1 x 170 Watts (1 x 280 Watts in 2 ohm). Built-in
high-pass, low-pass and subsonic filters. Variable phase control
on sub channel. High level input. Protection circuits shut down
the amplifier in the event of overloads. The perfect amplifier
for a standard installation with a front system in stereo and
a subwoofer in the back. High level input with auto start. |
| |
|

RMS RMS output per channel at 13,8 volts
Mode : AB
Number of channels : 3
Nominal power output in 4 ohm (0,1% THD) : 2 x 50 W
Maximum power output in 2 ohm (0,2% THD) : 2 x 80 W
Maxpower output mono channel in 4 ohm : 170 W
Max power output mono channel in 2 ohm : 280 W
Frequency range : 10 Hz - 30 kHz
S / N-ratio, A-weighted : > 100 dB
Damping factor : > 100
Input impedance low level : > 10 kohm
Input impedance, high level : 100 ohm
Input sensitivity, variable : 0,25 - 5 V
High level input with auto start : Yes
Low level output : No
Filter channel A & B : Highpass: 50-150 Hz.
Filter channel C : Lowpass: 50 - 120 Hz + subsonic 25 Hz
Phase control 0 - 180 degrees : Yes
Current draw, idle : 1,0 A
Fuse value : 2 x 30 A
Dimensions H x D x B : 51,5 x 350 x 290 mm (2,03 x 13,78 x 11,42 inch)
Weight : 4,6 kg ( 10 lb) |